Application Instructions

Rubber In A Can Application Instructions

Alvin Rubber in a can comes in a easy to use aerosol can. Shake well and apply to a clean dry surface. Hold the can 10-15 inches from surface for best results and spray multiple coats/layers. Applying one thick coat especially do a vertical surface will result in dripping/sagging and take longer to dry.

This product will apply a thick rubberized coating and will seep, seal and fill any crack, hole, imperfection and dry to a flexible rubber surface.

Apply Alvin Rubber in a can to any hard rigid surface. Temperature should be above 50°F.

Allow to air dry and topcoat with virtually any paint.

After each use, invert can and spray one quick burst to clear nozzle.

We urge Rubber In a Can users to test the suitability of the product for each application.

Use Alvin Lab solvent for clean up.

When applying Alvin Rubber in a can, keep in mind air temperature surface temperature, thickness, number of coats, surface preparation. In some cases, where there is a lot of water and pressure occuring, Rubber in a can is a temperary fix/solution. Contacting a reputable contractor might be necessary.

www.alvinproducts.com

****Rubber in a can cannot be used on a surface that is actively leaking!!!

 

Buy Online Now

PTEN Top 100